众彩网

Professionally engaged in research, design and manufacturing of agricultural and animal husbandry machinery
Sales of high-tech enterprises

support hotline:

400-0991-318

Corn harvester should pay attention to when working

Author: admin Published date: 2019-06-01 dimensional code sharing

Corn harvester is a common machine in agriculture. The following points should be noticed during use:

新疆玉米收获机

1. Inspection before trial operation. ① Check whether the bearing of each part and the high-speed rotating parts on the shaft (such as stem cutting device, intermediate shaft) are installed properly. ② Check the tension of V-belt and chain. ③ Check whether there are tools or unrelated items left on the working parts of the harvester, and whether all protective covers are in place. ④ Check whether the fuel, oil and lubricant are in place.


2. No-load test run. ① Disengage the engine clutch and put the shift lever in the neutral position. ② Start the engine and engage the clutch at low speed. When all working parts and various mechanisms operate normally, gradually increase the engine speed until the rated speed, and then make the harvester run at the rated speed.


3. Trial operation of corn harvester operation. Within the first 30 hours of work, it is recommended that the speed of the harvester be 20% to 25% lower than the normal speed. The normal working speed can be carried out at the working speed recommended by the manual. After the trial operation is over, thoroughly check the assembly and tightening of each component, the correctness of the assembly adjustment, and the working status of the electrical equipment. Replace all reducer and close the gearbox lubricant.


The above is the relevant content compiled and edited by Xinjiang corn harvester manufacturers for this time. Welcome everyone to continue to pay attention to this website.



success case

CASE SHOW

Express Lane

support hotline

400-0991-318 400-0991-318

Email: musthennj@foxmail.com

Q Q: 835686242